Jump to content

2016 MKZ Front Passenger Seat Removal


pwcopy

Recommended Posts

Trying to find step-by-step for removing and re-installing the front passenger seat on my 2016. I will need this if I take it to the upholstery shop for repair. Can't leave the car because I only have the one vehicle. And I'm single; so no help to and from shop to office, etc. I've googled "2016 MKZ Front Passenger Seat Removal," and no luck. Many thanks for your help, PW

Link to comment
Share on other sites

This is for a MY2015 but there should be no difference.

 

Removal

NOTE: Driver seat shown, passenger seat similar.
 

 

 

WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Ignition must remain OFF until repair is complete. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.

Turn the ignition OFF and wait at least one minute.

  1. Position the seat forward to access the seat rear bolts.
  2. Remove the bolt.
  3. Remove the bolt.

Seat1.jfif

Move the front seat to the full rearward position.

seat2.jfif

If a seat side airbag SRS (supplemental restraint system) fault is present, depower the SRS (supplemental restraint system).

DEPOWERING

  1. Turn the ignition OFF.
  2. At the BCM (body control module) , located under the instrument panel, to the left of the steering column, remove the BCM (body control module) fuse 35 (5A). Refer to Wiring Cell 11 Fuse and Relay Information See: Diagrams\Electrical\Diagrams By Number.
  3. Turn the ignition ON and monitor the airbag warning indicator for at least 30 seconds. The airbag warning indicator remains lit continuously (no flashing) if the correct RCM fuse is removed. If the airbag warning indicator is not lit continuously, remove the correct RCM fuse before proceeding.
  4. Turn the ignition OFF.
  5. Disconnect the battery

 

Remove the front seat bolt caps.

Seat3.jfif

 

Remove the bolts.

Seat4.jfif

 

  1. Disconnect the wire harness electrical connector.
  2. If equipped.

Disconnect the heated seat electrical connector and remove the front seat.

Seat5.jfif

© 2019 ALLDATA, LLC

Hope this helps.  Good luck with the removal and repair.

 

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...