Obiejuan Posted June 21, 2017 Share Posted June 21, 2017 Just wondering if there is a way to adjust the glass closing on the Sun Roof. My Mkz 2008 opens and closes but when it closes it doesn't flip upwards like it use to. Any help will be greatly appreciated Quote Link to comment Share on other sites More sharing options...
4N1M4L Posted June 21, 2017 Share Posted June 21, 2017 I adjusted the glass on my '10 to make it line up more to my liking. The accordion covers clip off easily. this reveals torx screws which when loosened allow the glass to be adjusted. The screws are only visible when open, so i had to open, adjust, then close to check. once this was done i clipped the accordion back into place. If this doesn't help you should probably include a picture of the thing to help illustrate your predicament. Quote Link to comment Share on other sites More sharing options...
Obiejuan Posted June 21, 2017 Author Share Posted June 21, 2017 Thanx, dark out now tomorrow ill make my attempt at being moon doggie repairman Quote Link to comment Share on other sites More sharing options...
drolds1 Posted June 21, 2017 Share Posted June 21, 2017 (edited) Try re-initializing it first: 1. Turn the ignition to the RUN position.For a new roof opening panel motor, press and hold the roof opening panel control switch forward until the roof opening panel glass moves to the full VENT position.NOTE: Make sure the front door is open during this step.2. Cycle the ignition from ON to OFF and then back to ON.3. Within 5 seconds: press and release the roof opening panel control switch forward. (VENT)4. Press and hold the roof opening panel control switch forward. (VENT)5. Continue holding the roof opening panel control switch forward for 5 seconds after the roof opening panel motor stops moving to confirm this position to the roof opening panel motor.6. Release the roof opening panel switch and test the system for normal operation by checking the one-touch open, one-touch close, one-touch vent and close operations. Five complete cycles must be carried out for the roof opening panel motor to be correctly initialized. 7. (NOTE: Only complete open and close motions count towards the cycle count. If the roof opening panel reverses during closing operations, perform the cycles with the roof opening panel control switch continuously held during the closing motions.) Edited June 21, 2017 by drolds1 moved to appropriate forum by moderator 4N1M4L 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.