Jump to content

riff raff

MKZ Member
  • Posts

    112
  • Joined

  • Last visited

  • Days Won

    3

Profile Information

  • My MKZ's Year
    2014
  • My MKZ
    MKZ

Recent Profile Visitors

1,329 profile views

riff raff's Achievements

Newbie

Newbie (1/14)

  1. If my 2014 has ANC, it doesn't work very well! I think it is my 3.7L motor - it's the loudest I've been in (vs GM/Toyota NA V6's). I do have what I've always thought was a sensor on top of the center of the dash.
  2. Ah, thanks, that makes sense. Not sure my car has ANC. I have the window sticker in my garage file, would it be listed on that? (bought it used)
  3. Well, I'm now at 195,000 miles and the rear rotors were warped pretty severely. What I thought was going to be a simple job was a real PITA and I ended up replacing both calipers. After entering service mode and replacing the calipers/pads, I was getting intermittent issues with both calipers not releasing. I finally had my buddy's service station look at it, he suggested the calipers be replaced. I picked up pair from a DC area dealer (they are hard to find!) and that solved the problem. I just drove it 2,500 mile to Louisiana and back, no issues. I had previously installed new rotors/pads on the front with no drama.
  4. Late to the party here, I just bought the OBDLinkEX adaptor and successfully installed the FORScan software and driver. Unit connects properly. After 194,000 miles, I figured "why not". I would primarily like to disable the fake engine noise - is that possible on my 2014 (3.7L)
  5. Yep, they all have anti-seize now! But at 200k, future rotor changes will be someone else's problems.
  6. Crap, I forgot that I have a jaw puller like that. I spend at least 40 minutes trying alternate methods....
  7. Recent update - at 190,000 miles, my rear rotors were heavily scored and warped. I replaced them with a set of NAPA premium rotors and their ceramic pads. (they had plenty of life, just scored) I had also recently replaced the front rotors/pads but the rears were more challenging to get off. I could not find the correct screw to push the rotor off the axle hub and ended up using PB Blaster and a big pry bar. All back together, it just took about double the amount of time as the fronts did.
  8. I'd call Lincoln again and tell them you struck out (or try the dealer you purchased the car from - make it their problem). I assume this is the PCU recall for the catalytic convertor? (mine is out in the car).
  9. Well, I just replaced my left bank exhaust manifold & Cat. Holy S....what a PITA (2014, 3.7L motor). The POS aftermarket manifold I put on in 2018 had two cracks. Rock Auto covered it under the five year warranty, but the mental and physical scars from the installation will haunt me forever. If an oil change is a 2 on a 1-10 difficulty scale, this was an 8. All told, it took me about 8 hours from start to finish. Getting to the fasteners was an exercise in frustration and I used all manner of sockets/extensions,u-joints and wrenches. The studs came out, so I put in six new ones (which greatly simplified installation). The car has been louder at start up for several months and my MPG dropped by about 3 mpg. I knew it must have been cracked. My neighbor, who owns the local service station put in the 1st one and said it was pretty difficult. That cost me $400 (plus $200 for the cat). Lincoln wanted $1,100 for the job. Back in 2018, I assumed the Lincoln cat would be pretty pricey, so I went via Rock Auto. A Lincoln cat is only $290 via the Ford Internet parts houses, wish I had gone that route in 2018. That cat also did not solve the P0430 code, so I've been using a spark plug fouler for the past year to avoid the code. I think that first manifold might have been cracked from the get-go. Now quiet and no code or pending codes and my first tank of gas is back to over 26 mpg. I'm just realizing now that I didn't take any photos. Pray you 3.7L people never have to do this. I sure hope my right manifold holds up. The good news is the replacement manifold from Rock Auto was visibly of a better quality, made by Davico. The car currently has 172,000 miles on it.
  10. Purchased a new low profile jack last year - problem solved. On the front, I just use the support member just in front of the motor. On the rear, I put a 4" extension piece on the jack pad (see attachment) and go up between the suspension mount.
  11. I never updated mine, that link is dead - what did you search for on Ebay? Lincoln sent me a flyer to upgrade for $149. I have never used the NAV (Wayz on my phone is easier), but I want to keep it updated for future resale.
  12. I was considering getting rid of that noise reduction box as well! I'm due for a drain/fill in a few thousand miles.
  13. That's pretty wild and a bit disappointing. I'd say to the service center, I'll need 10 free oil changes OR you can disassemble and clean my entire cabin air system to clear it for dead mice/vermin, your call. (doubt there are any dead mice inside). I've never changed my cabin air filter......
  14. Gotcha - you qualify (SBC - small British car!)
×
×
  • Create New...